Tools required:Tape measure, Rose bush cutter/Pruning shears Easy Installation - Note: Test-fit frame prior to installing lights in frame. 1. Measure window from sill to top window jamb (A). Cut lengths to approximately 1/8 inch less than window vertical dimension (A). ...necessary to allow for rubber end caps. Note: Plastic rods are shipped with caps in place. After cutting, replace caps. 2. Build your frames in your windows by friction fitting left and right lengths in window. Notches should face indoors. Note: caps may be used to compensate for slight measuring/cutting errors. 3. Cut horizontal supports. Horizontal dimension (B) should be the distance between the vertical rods plus 3" allowing for 1½" to extend on each side. 4. Snap knob of horizontal support into notch of vertical length. 5. Remove frame from window and place on table or floor. Slide miniature lights into notches Make sure plug is at bottom of frame. 6. Place frame in window between sill and top window jamb with notches (lights) facing indoors (away from glass). 7. Window Wonder light holders are made of durable plastic.
Installation Hints:
© 1999 - 2007 by Affordable Web Designs all rights reserved. |